Visioneer OneTouch 8700 Guía de instalación descargar pdf (Pagina 15)

VISIONEER ONETOUCH 8700 SCANNER INSTALLATION GUIDE

4. Click OK to close the dialog box.

That’s it. Your scanner is ready to scan.

See “Scanning by Pressing the OneTouch Buttons” on page 14.

THE

CANNER

ROPERLY

ONNECTED

If the scanner icon on the Windows taskbar has a red “X” through it,

the scanner is not properly connected.

Check for one of these possible problems:

•

Is a cable loose or not plugged in securely? Inspect all cable

connections. Make sure all the cables are plugged in securely.

•

Is the scanner’s power light on? Turn on the scanner’s power. If the

light still doesn’t come on, plug the power adapter into another

electrical outlet.

•

Is the scanner’s locking tab in the locked position? Slide the

locking tab to the unlocked position. If you tried to scan with the

scanner locked, you must restart your computer after unlocking the

scanner.

•

Did you restart the computer after installing the software? If you

didn’t restart the computer, it may not have loaded all of the software

files. Try restarting your computer.

Note: The scanning lamp under the scanner’s glass needs to warm up

before you can scan. A status message lets you know when the lamp is

ready. The lamp then remains ready so you don’t have to wait for it to

warm up each time you want to scan. To conserve electricity and

prolong the life of the scanner, you can set the length of time for the

lamp to remain lit before powering down. See “Setting Preferences”

on page 25.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 57 58

Sin comentarios

Visioneer OneTouch 8700 Guía de instalación Pagina 15